Industrial Air Conditioner (IAC) is an essential part of most factories, workshops, and warehouses. Without these systems, the productivity at work would be severely affected and ultimately, the company as a whole would suffer.
In order to maintain the temperature levels inside these working environments, it is crucial that professionals know how to properly maintain this equipment.
In addition to cleaning the various components of the system, experts also perform other important services such as lubricating and assembling various parts. You can visit at https://heroservices.com/knoxville-tn/hvac/hvac/ check how professionals make their strategies for effective cleaning.
Before you can begin cleaning, the cooling system must be shut down. It is important that all power cords are disconnected to prevent loss of heat while the system is being cleaned. Once the system is off, the entire area should be cleaned.
This includes access panels, coils, ducts, and fans. The cleaning process must be done according to the manufacturer’s instructions. You can determine the cleaning frequency by testing the system first before proceeding to the actual cleaning process.
Vacuum your system to remove dust and debris. While doing this, make sure to use the correct equipment as per the system’s specifications. Low-powered units may not be able to remove all the materials from your system, so you need to be careful to follow the specific cleaning frequency set by your conditioning system.
After completing the cleaning procedure, ensure that all the parts are dry. If your conditioning system uses an accumulator, it needs to be flushed as well to remove any materials clogging the drain.
You can choose to either wash the system by hand or by using an air compressor. Whichever method you use for cleaning, it is important to wear protective gloves as it could be hazardous to your health.
Start the process by spraying the accumulator with a strong jet of water. Allow the wash to run for approximately ten minutes before you switch the air conditioner on and wait for the water to drain and wash the system thoroughly.
Next, using a high pressure jet of water you can rinse the condenser coils located on the exterior. Ensure that you rinse the condensers completely and wipe off any build-up using a clean rag or paper towels.
After the condensers have been washed, replace them back onto the unit. Before reconnecting them to the air-conditioning unit, open them up using a high-heat iron. Repeat the steps for each coil on the outside of the system.
When you have finished cleaning, switch on the power, and see if your unit responds well. If not, continue using the wash cycle and check on the condition of your air conditioner.
If there are still leaks inside, or condensation forming on the interior surface of the condenser coil, continue washing until you achieve results. When everything is ready to be changed, open the doors and windows of the unit to allow any excess water to escape.
As you close all the windows and doors, spray some outdoor solvent cleaner onto the surfaces where you will seal in the moisture after using the pressure washer to wash the parts. You may have to repeat the above process several times before finally achieving the desired results.
Note that you will probably have to wash a large section of your industrial air conditioning unit. This is because the process usually involves washing the entire unit including the outside casing, pipes, and fan blades.
However, it is possible to clean just the outside casing by using a vacuum cleaner. Do this part of the process slowly and gently to avoid damaging the unit. Once you have successfully completed the first stage of cleaning, you will have to wait for a day before continuing with the next stage.
The reason why you should wait is so that the conditioning unit is able to dry out completely. The next stage of cleaning includes removing all the debris that you were able to wash off using your vacuum cleaner.
Once you have washed off all of the debris, you will have to wipe or spray the condensing tubes with a solvent cleaner. The solvent cleaner will remove any excess dirt or grease that remains on the tubes after the condensing unit has dried up completely.